×

turbidity removal meaning in Chinese

除浊

Examples

  1. Study on property of turbidity removal of pdmdaac flocculant series
    二甲基二烯丙基氯化铵聚合物的除浊性能研究
  2. The result shows that the optimum coagulation ph of isp is about 7 - 8 . for aluminium sulfate ( al2 ( 804 ) 3 ) , the optimum dose is 1 . 875mgal / l , while for poly aluminium chloride ( pac ) , the optimum dose is 1 . 5mgal / l . both coagulants can achieve 90 % turbidity removal
    实验结果表明:无机悬浮颗粒体系的最佳混凝ph值在7 8之间,在硫酸铝和pac混凝剂条件下的最佳投药量分别为1 . 875mgal l和1 . 5mgal l ,两者对浊度都能达到90左右的去除。
  3. The output signal of pda is affected by the suspended particle concentration , particle size , and the type and dosage of coagulant as well . by analysing the fi curve , it is found that the characteristic parameters of fi curve closely relate to aggregates size and turbidity removal the aggregates size and turbidity removal achieve the maximum when the amplitude of fluctuation is the maximum . the mean diameter and fractal dimension increase with agitation time , and finally reach a steady - state
    通过对混凝过程的在线监测和对pda输出信号fi曲线的数学解析表明: fi曲线综合反映了悬浊液中胶体颗粒浓度和颗粒粒径,混凝剂种类和投量很大程度上影响了fi曲线形状, fi曲线的特征值与絮凝体平均粒径和浊度去除率之间具有良好的相关关系,在振幅最大处,浊度去除率达到最高,絮体平均粒径最大,该条件下对应的投药量为最佳投药量。

Related Words

  1. silky turbidity
  2. turbidity factor
  3. remove turbidity
  4. turbidity test
  5. atmosphere turbidity
  6. dextrin turbidity
  7. damp turbidity
  8. turbidity unit
  9. turbidity screen
  10. turbidity temperature
  11. turbidity reducing unit
  12. turbidity reference standard
  13. turbidity scale
  14. turbidity screen
PC Version

Copyright © 2018 WordTech Co.